What's trending!
Exsolar
  • Home
  • About
    • Meet us
  • Our Installations
  • Systems
    • Grid Tied Systems
    • Camping & 4x4 kits
    • Backup Systems
  • Products
    • Victron Inverters
    • Fronius Inverters
    • Kaco Inverters
    • Lead Calcium Batteries
    • Gel & AGM Batteries
    • Lithium Iron Phosphate Batteries
    • Flooded Deep Cycle Batteries
    • FLA Batteries
    • Poly Panels
    • Mono Panels
    • Grid Tie Limiting
    • Monitoring
    • Mounting Structures
    • Solar Chargers
    • Battery Monitors, Isolators & Combiners
    • Isolators, Combiners & DC Systems
    • Accessories
    • Cables
    • System Monitoring
  • Specials
  • Contact Us
    • FAQ
    • Training
  • Home
  • About
    • Meet us
  • Our Installations
  • Systems
    • Grid Tied Systems
    • Camping & 4x4 kits
    • Backup Systems
  • Products
    • Victron Inverters
    • Fronius Inverters
    • Kaco Inverters
    • Lead Calcium Batteries
    • Gel & AGM Batteries
    • Lithium Iron Phosphate Batteries
    • Flooded Deep Cycle Batteries
    • FLA Batteries
    • Poly Panels
    • Mono Panels
    • Grid Tie Limiting
    • Monitoring
    • Mounting Structures
    • Solar Chargers
    • Battery Monitors, Isolators & Combiners
    • Isolators, Combiners & DC Systems
    • Accessories
    • Cables
    • System Monitoring
  • Specials
  • Contact Us
    • FAQ
    • Training

Leaders in solar energy

Isolators, Combiners, Converters & DC Distribution

Battery Isolators & Combiners

Picture

​Argo Diode Battery Isolators

​Diode Battery Isolators allow simultaneous charging of two or more batteries from one alternator, without connecting the batteries together. Discharging the accessory battery for example will not result in also discharging the starter battery. Low voltage drop due to the use of high efficiency Schottky diodes.
Datasheet Argo Diode Battery Isolators.pdf
File Size: 113 kb
File Type: pdf
Download File


Picture

Argo FET Battery Isolators

​Similarly to diode battery isolators, FET isolators allow simultaneous charging of two or more batteries from one alternator (or a single output battery charger), without connecting the batteries together. In contrast with diode battery isolators, FET isolators have virtually no voltage loss. Voltage drop is less than 0,02 Volt at low current and averages 0,1 Volt at higher currents.
datasheet-argo-fet-battery-isolators-with-alternator-energize-input-en.pdf
File Size: 131 kb
File Type: pdf
Download File


Picture

Argo Diode Battery Combiners

​Diode Battery Combiners are used to guarantee continuous DC power to mission critical equipment, such as an electronic engine control system. With a Diode Battery Combiner two or more DC power sources can be used in parallel to supply the mission critical load. Failure of one source will not interrupt power to the critical load.
Datasheet Argo Diode Battery Combiners.pdf
File Size: 127 kb
File Type: pdf
Download File


Picture

Cyrix-i Battery Combiner Kit

​This Battery Combiner Kit is for adding a 2nd or 3rd battery system in your car, boat, RV or any other vehicle. It utilizes the simplest and most advanced technology to keep all your batteries charged using the engine’s electrical system, but isolates the starting battery when charging ceases so you never get stranded.
Manual Cyrix Battery Combiner Kit.pdf
File Size: 58 kb
File Type: pdf
Download File


Picture

​Cyrix Battery Combiners

The Cyrix Battery Combiner is a microprocessor controlled heavy duty relay that automatically connects batteries in parallel when one of them has reached a pre-set voltage (indicating that the battery is being charged), and disconnects when the voltage decreases below float level (indicating that one or more batteries are being discharged). Cyrix Battery Combiners are an excellent replacement for diode isolators. The main feature is that there is virtually no voltage loss so that the output voltage of alternators or battery chargers does not need to be increased.
Models:120A / 230A / 400A
Datasheet Cyrix CT 120a-230a.pdf
File Size: 234 kb
File Type: pdf
Download File

Datasheet Cyrix-i 400a.pdf
File Size: 122 kb
File Type: pdf
Download File

Datasheet Cyrix-Li-Ion 120a.pdf
File Size: 386 kb
File Type: pdf
Download File

Datasheet Cyrix-Li-Ion 230a.pdf
File Size: 503 kb
File Type: pdf
Download File

Battery Protect


Picture

BatteryProtect

​The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.
Datasheet BatteryProtect 48v/100a.pdf
File Size: 200 kb
File Type: pdf
Download File

Datasheet Battery Protect 65a/100a/220a.pdf
File Size: 231 kb
File Type: pdf
Download File


DC-DC Converters 

Picture

Orion-Tr DC-DC Converters Isolated

Remote on-off: The remote on-off eliminates the need for a high current switch in the input wiring. The remote on-off can be operated with a low power switch or by for example the engine run/stop switch (see manual). 
Adjustable output voltage: can also be used as a battery charger. For example to charge a 12 Volt starter or accessory battery in an otherwise 24V system.  All models are short circuit proof and can be paralleled to increase output current. An unlimited number of units can be connected in parallel.  IP43 protection: When installed with the screw terminals oriented downwards.  Screw terminals: No special tools needed for installation. Input fuse: On 12V and 24V input models only.
Models:   12 / 24 / 48 Volt
Datasheet Orion-tr DC-DC Converters Isolated 100/250/400w.pdf
File Size: 704 kb
File Type: pdf
Download File


Picture

​Orion-Tr DC-DC Converters Non-isolated

High efficiency
Using synchronous rectification, full load efficiency exceeds 95%. IP43 protection
When installed with the screw terminals oriented downwards. 
Screw terminals
No special tools needed for installation.
Models:24 Volt
Datasheet Orion-tr DC-DC Converters low power Non-isolated.pdf
File Size: 75 kb
File Type: pdf
Download File


Picture

Orion DC-DC Converters Non-isolated, High power

Remote on-off connector
The remote on-off eliminates the need for a high current switch in the input wiring. The remote on-off can be operated with a low power switch or by the engine run/stop switch (see manual). All models with adjustable output can also be used as a battery charger
For example to charge a 12 Volt starter or accessory battery in an otherwise 24V system. 
All models with adjustable output can be paralleled to increase output current
Up to five units can be connected in parallel.
Models:12 / 24 Volt
Datasheet Orion DC-DC Converters. High Power Non-isolated.pdf
File Size: 111 kb
File Type: pdf
Download File


Picture

Orion DC-DC Converters Isolated, 360W and special purpose models

Models:  12 / 24 / 48 / 100 Volt
Datasheet Orion Isolated 360w and Special Purpose Models-en.pdf
File Size: 64 kb
File Type: pdf
Download File


Picture

Orion IP67 24/12 DC-DC Converters ​

Completely encapsulated: waterproof, shockproof and ignition protected
Water, oil or dirt will not damage the Orion IP67 DC-DC Converter. The casing is made of cast aluminium and the electronics are moulded in resin. 
Available in 3 models
Orion IP67 24/12-5
Orion IP67 24/12-10
Orion IP67 24/12-20
Models:24 Volt
Datasheet Orion IP67 24/12 DC-DC Converters.pdf
File Size: 104 kb
File Type: pdf
Download File


Picture

Buck-Boost DC-DC Converter 25A and 50A

DC-DC Converter for charging a 12/24V service battery in vehicles with an intelligent dynamo. The 50A Buck-Boost DC-DC Converter is a DC-DC converter for charging a 12/24V service battery in vehicles with an intelligent dynamo. Since, when the engine is running, these dynamos (powered by the on-board electronics of Euro 5 and 6 engines) do not always emit the correct charging current, a DC-DC converter is essential for charging the service battery properly.
Datasheet Buck Boost DC-DC Converter 25a & 50a.pdf
File Size: 193 kb
File Type: pdf
Download File


DC Distribution Systems

Picture

Lynx Ion BMS

The Lynx Ion BMS is the Battery Management System that goes with the Lithium HE batteries and our Lithium 24V batteries. It has a built-in safety disconnect switch, and manages cell-balancing, battery balancing and charging and discharging of the system. The Lynx Ion BMS protects the battery pack from both overcharging and depletion.
Datasheet Lithium Ion-he Battery and Lynx Ion BMS.pdf
File Size: 429 kb
File Type: pdf
Download File


Picture

Lynx Power In ​

​A modular DC bus bar, used to connect batteries to the Lynx DC distribution system.

Picture

Lynx Distributor

​A modular DC bus bar, with locations for four DC fuses. It will monitor the status of each fuse, and indicate its condition with a LED on the front. Part of the modular Lynx distribution system.

Picture

Lynx Shunt VE.Net

​The Lynx Shunt VE.Net is an intelligent 1000A shunt with location for a fuse, the built in battery monitor accurately monitors the state of charge on your battery. Use the Blue Power Panel or VE.Net panel for reading out the information. Part of the modular Lynx distribution system.

Lynx Shunt VE.Can ​

​The Lynx Shunt VE.Can is an intelligent 1000A shunt with location for a fuse, the built in battery monitor accurately monitors the state of charge of your battery. Use the Color Control GX for reading out the information. Part of the modular Lynx distribution system.

Picture

Lynx Ion + Shunt 350/600 ​

​The Lynx Ion is the Battery Management System (BMS) that controls the 24V/180Ah Lithium Ion batteries. It contains the 350A safety contactor, and controls the cell-balancing, charging and discharging of the system. The Lynx Ion will protect the battery pack from both overcharging and depletion.
datasheet-lithium-ion-and-lynx-ion-en-2.pdf
File Size: 393 kb
File Type: pdf
Download File


Picture

ESP DC Link Box

The DC Link Box brings all the primary DC protection, DC monitoring and sensor connections into one simple to fit enclosure. It includes: 
- 4 Mega fuses (2x 300A, 1x 200A, 1x 100A) and 1 Midi fuse (60A). These can be changed to suit the user's requirements. Mega fuses are available in sizes from 100 to 500 amps and Midi fuses from 30 to 125 amps.
- 500 Amp shunt.
- Test button with LEDs for all 5 fuses and a polarity warning LED.
- Fused connection points for MultiPlus voltage sense and BMV-600 connections.
- Fused connections for magnetically latching battery isolator which can be controlled via ESP system panel.
- RJ 11 and 45 socket connections for ESP system panel.
Link Box V5 Instructions Victron.pdf
File Size: 371 kb
File Type: pdf
Download File


    Interested in Solar? Drop us a message for a free quote or advice...

Submit
Disclaimer: Please note that ALL pricing on the website an estimate and subject for change due to stock availability. 

    Get in touch...


    (Please include your contact number, your preferred currency & your delivery address - if applicable)
Submit

​Tel

Email

Hours

+27 21 8511700
energy@exsolar.co.za
M-F: 8am - 5pm